Fireworks Firing System DIY Components
EasyClips:
We developed EasyClips for firing systems, so that connecting and removing igniters become very easy, and the EasyClips 2P saves 80% time. These clips are so helpful for big shows to reduce the labor and save time. On the other hand, the clips make a firing system look very prefessional. If you are a hobbyist of DIY firing system, it is a great component.Although it is so easy for EasyClips to connect or remove igniters, the connection is very tight.
RR12-CONF
12CH board with heavy traces and SMA antenna connector, can flow more than 10A current. Is configurable to be multiple working modes like below.
Specifications
We also provides wireless relay receivers and remotes / transmitters for DIY. Normally it is OOK type, 433.92MHz. They are all configurable so that the units meet your requirements. There units perform so well, many many people bought these remotes and boards.
Recommended Items
-
EasyClips 1P
Clips are specially for the connection of igniters, easy to insert wires, connection is tight. This clips can be inserted one wire each time.
$1.2 per unit
-
EasyClips 2P
Clips are specially for the connection of igniters, easy to insert 2 wires of an igniter, connection is tight. Save 80% time to connect or remove igniters.
$2 per unit
-
RR1LNC
Single Channel Relay Receiver, Learning Code type, 4 control modes are built in the same unit.
$9.6 per unit
-
RR2LNC
2 Channel Relay Receiver, Learning Code type, 4 control modes are built in the same unit for each channel. Each of the two channels can work individually.
$13.2 per unit
-
RR12-CONF
RF Wireless Radio 12CH Relay Receiver RR12-CONF, Heavy traces can work with heavy current, Superheterodyne high sensitivity, Working mode is configurable: 12M, 12L, 8M4L, 6M6L & 10M2L.
$31.2 per unit
Safe, easy & reliable, with remote controllable service. Copyright © 2023 Guangzhou RFRemotech Electronic Technology Co., Ltd. All rights reserved.